The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the park/neutral position switch assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
33820B
4.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
84540
5.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disconnect the park/neutral position switch assembly connector.
| *a | Piece of Wood or Equivalent |
Using a piece of wood or equivalent to secure the transmission control shaft lever to prevent it from rotating, remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.
| *1 | Transmission Control Shaft Lever |
| *2 | Manual Valve Link Lever Sub-assembly |
| *3 | Manual Valve |
If the transmission control shaft lever is not secured when loosening the nut, the manual valve link lever sub-assembly may separate from the manual valve.
Loosen the 2 bolts of the park/neutral position switch assembly.
| *a | Protrusion |
Align the protrusions of the park/neutral position switch assembly as shown in the illustration.
Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.
Install the transmission control shaft lever to the manual valve lever shaft with the washer and nut.
Connect the park/neutral position switch assembly connector.
33820B
6.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
84540
8.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
9. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART