Home › Engine / Hybrid System › M15A-FKS (FUEL) › FUEL PRESSURE SENSOR (for High Pressure)
RM36W0E _51 Engine / Hybrid System _088660 M15A-FKS FUEL _0422102 FUEL PRESSURE SENSOR(for High Pressure) A

M15A-FKS FUEL  FUEL PRESSURE SENSOR(for High Pressure)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89458 1.INSTALL FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the fuel pressure sensor.

Click hereEngine / Hybrid System>M15A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A464845C01
1.323,0.729 0.938,0.729 true 2.813,1.031 2.479,1.177 true 0.729,0.635 0.917,0.813 0.188,0.177 10 true *a 2.813,0.927 3,1.104 0.188,0.177 10 true *b
*a Cutout (Fuel Delivery Pipe)
*b Cutout (Fuel Pressure Sensor)


Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.

NOTICE:

Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.



b.
A464846C01
1.344,0.719 0.958,0.719 true 3.135,1.073 2.802,1.323 true 0.75,0.635 0.958,0.823 0.208,0.188 10 true *a 3.125,0.979 3.323,1.146 0.198,0.167 10 true *b
*a Cutout (Fuel Pressure Sensor)
*b Cutout (No. 1 Fuel Pressure Sensor Holder)


Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.

NOTICE:

Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.



c.
A464847

Using an 8 mm socket wrench, install the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.
A464848

Connect the fuel pressure sensor connector.


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 6.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the fuel pressure sensor.

Click hereEngine / Hybrid System>M15A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION