Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM36W0E _56 Audio / Visual / Telematics _088616 NAVIGATION / MULTI INFO DISPLAY _0422142 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B153A  GVIF Disconnected (from Extension Module to H/U)  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B153A GVIF Disconnected (from Extension Module to H/U) GVIF disconnected (from navigation ECU to radio and display receiver assembly)
·

Navigation ECU

·

Radio and display receiver assembly

·

Harness or connector



WIRING DIAGRAM

E379947E18
1.281,0.844 1.719,1.083 0.438,0.24 10 false GVO+ 0.802,2.177 1.24,2.417 0.438,0.24 10 false H122 0.792,2.333 1.833,2.583 1.042,0.25 10 false Navigation ECU 0.917,3.385 1.896,3.625 0.979,0.24 10 false : GVIF Cable 1.854,0.719 2.292,0.958 0.438,0.24 10 false 2 1.854,1.177 2.292,1.417 0.438,0.24 10 false 1 1.854,1.656 2.292,1.896 0.438,0.24 10 false 3 1.323,1.292 1.76,1.531 0.438,0.24 10 false GVO- 1.313,1.74 1.75,1.979 0.438,0.24 10 false GVG1 5.458,0.854 5.896,1.094 0.438,0.24 10 false GV2+ 5.469,1.281 5.906,1.521 0.438,0.24 10 false GV2- 5.479,1.74 5.917,1.979 0.438,0.24 10 false GVG2 5.313,2.177 5.75,2.417 0.438,0.24 10 false H121 5.323,2.323 6.719,2.75 1.396,0.427 10 false Radio and Display Receiver Assembly 5.219,1.646 5.656,1.885 0.438,0.24 10 false 3 5.208,1.177 5.646,1.417 0.438,0.24 10 false 1 5.198,0.729 5.635,0.969 0.438,0.24 10 false 2 3.115,3.375 5.052,3.563 1.938,0.188 10 false *: Shielded 3.552,1.667 4.042,1.792 0.49,0.125 10 false *

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.




PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
DTCs are output A
DTCs are not output B



A

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)

B

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the H122 navigation ECU connector.


b.

Disconnect the H121 radio and display receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H122-1 (GVO-) - H121-1 (GV2-) Always Below 1 Ω
H122-2 (GVO+) - H121-2 (GV2+) Always Below 1 Ω
H122-3 (GVG1) - H121-3 (GVG2) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

4.REPLACE NAVIGATION ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE NAVIGATION ECU
a.

Replace the navigation ECU with a new one.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

5.CLEAR DTC
5.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

Result:
Proceed to
NEXT



NEXT

6.CHECK FOR DTC
6.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
DTCs are output A
DTCs are not output B



A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

B

END (NAVIGATION ECU IS DEFECTIVE)