Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › ECM
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422220 ECM A

M15A-FXE ENGINE CONTROL  ECM  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 89667E 1.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the screw.

Torque:
5.25 N*m (54 kgf*cm, 46 in.*lbf)


Hide 89668 2.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the screw.

Torque:
5.25 N*m (54 kgf*cm, 46 in.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the bolt and nut.

Torque:
Bolt : 10 N*m (102 kgf*cm, 7 ft.*lbf)
Nut : 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



b.
A463040

Engage the clamp.


c.

Connect the 2 ECM connectors and lower the 2 lock levers.

NOTICE:
·

When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

·

Be sure to securely connect the ECM connectors.




Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART