Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422223 CRANKSHAFT POSITION SENSOR A

M15A-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 11401G 1.INSTALL CRANK POSITION SENSOR

a.
A427574

Clean the O-ring groove of the crankshaft position sensor.

NOTICE:

Make sure the O-ring groove is free of foreign matter.



b.

Install a new O-ring to the crankshaft position sensor.

NOTICE:

Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.



c.

Check if the O-ring is twisted.

HINT:

Check the entire circumference of the seam of the O-ring for twisting.



d.

Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




e.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK

Hide 51451A 3.INSTALL CENTER ENGINE UNDER COVER