Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422223 CRANKSHAFT POSITION SENSOR A

M15A-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 11401G 2.REMOVE CRANK POSITION SENSOR

a.
A463110

Disconnect the crankshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



c.

Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.