Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › KNOCK SENSOR
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422226 KNOCK SENSOR A

M15A-FXE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Air leaks from intake system

·

Replacement of knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.
A463117

Disconnect the knock sensor connector.


b.

Remove the bolt and knock sensor from the cylinder block sub-assembly.

NOTICE:

If the knock sensor has been struck or dropped, replace it.