Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1)
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422227 AIR FUEL RATIO SENSOR(for Sensor 1) A

M15A-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A463032C01
1.51,1.396 1.688,1.156 true 2.25,0.344 2.5,0.552 0.25,0.208 10 true *a 1.292,1.427 1.656,1.656 0.365,0.229 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.

Engage the 3 clamps.


c.

Connect the air fuel ratio sensor connector.


Hide 55701J 2.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 55815E 3.INSTALL NO. 1 FRONT VENTILATOR SEAL

Hide 5.INSTALL WINDSHIELD WIPER MOTOR AND LINK

Hide 7.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION