Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2) › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422228 AIR FUEL RATIO SENSOR(for Sensor 2) A

M15A-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 2 air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of air fuel ratio sensor (sensor 2) Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Gas leak from exhaust system is repaired

CAUTION:
·
A344784

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 51447D 1.REMOVE NO. 4 ENGINE UNDER COVER CENTER

Hide 2.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A463079

Disengage the guide to disconnect the wire harness from the wire harness clamp bracket.


b.

Remove the wire harness clamp bracket from the No. 2 air fuel ratio sensor.


Hide 89467C 3.REMOVE NO. 2 AIR FUEL RATIO SENSOR

a.
A463080

Disconnect the No. 2 air fuel ratio sensor connector.


b.

Disengage the 2 wire harness clamp.


c.
A463081N02
1.76,0.76 2.063,0.479 true 2.094,0.344 2.5,0.542 0.406,0.198 10 true SST

Using SST, remove the No. 2 air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

NOTICE:

If the No. 2 air fuel ratio sensor has been struck or dropped, replace it.