1.INSPECT TIRES
Inspect the tires for wear and proper inflation pressure.
| Tire Size | Front
kPa (kgf/cm2, psi) |
Rear
kPa (kgf/cm2, psi) |
|---|---|---|
|
*1: For driving under 160 km/h (99 mph) *2: For driving at 160 km/h (99 mph) or over |
||
| 175/70R14 84S | 250 (2.5, 36) | 240 (2.4, 35) |
| 185/60R15 84H | 230 (2.3, 33) | 220 (2.2, 32) |
| 185/55R16 83V | 220 (2.2, 32)*1
230 (2.3, 33)*2 |
210 (2.1, 30)*1
220 (2.2, 32)*2 |
| Tire Size | kPa (kgf/cm2, psi) |
|---|---|
| T125/70D16 96M | 420 (4.2, 60) |
Using a dial indicator, check the runout of the tires.
1.4 mm (0.0551 in.)
2. ROTATE TIRES
Remove the wheel assembly.
|
Front |
Rotate the tires as shown in the illustration.
Install the wheel assembly.
3.INSPECT AND ADJUST WHEEL BALANCE
Inspect and adjust the off-the-car balance.
for Steel Wheel:
8.0 g (0.0176 lb)
Use clip-on type balance weights for both the inner and outer side.
If the tires vibrate even after the off-the-car balance adjustment, adjust the wheel balance with on-the-car balancing as necessary.
| *a | 25 mm (0.984 in.) |
for Aluminum Wheel:
8.0 g (0.0176 lb)
Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
Do not touch the adhesive surface of the balance weight.
Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
Push the balance weight with your finger to securely adhere it to the desired position.
Do not reuse balance weights.
Use only TOYOTA genuine stick-on type balance weights or equivalent.
Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.
If the tires vibrate even after the off-the-car balance adjustment, adjust the wheel balance with on-the-car balancing as necessary.
4.INSPECT FRONT AXLE HUB BEARING
5.INSPECT REAR AXLE HUB BEARING