Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU › 2020.03–2020.07
RM36W0E _55 Steering _087549 POWER ASSIST SYSTEMS _0424124 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the power steering ECU with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Power steering ECU with motor assembly Assist map writing
·

DTCs are stored

·

EPS warning light illuminates


(Click here)
Update ECU security key Vehicle control history (RoB) are stored (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 45020B 2.REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

Hide 89650 3.REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY

NOTICE:
·

Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness of the electric power steering column sub-assembly.

·

Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU with motor assembly.



a.
C433970

Disconnect the connector.


b.

Disengage the clamp.


c.
C433971

Remove the bolt and harness bracket from the electric power steering column sub-assembly.


d.
C433972

Remove the 2 bolts and power steering ECU with motor assembly from the electric power steering column sub-assembly.


Hide 45254B 4.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

a.
C433973

Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.