Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › 2020.03–2020.07
RM36W0E _55 Steering _087550 STEERING COLUMN _0424130 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness.

·

Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU with motor assembly.



PROCEDURE

Hide 45020B 1.REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a drill, drill a hole in the 2 steering lock set bolts and insert a screw extractor.


c.
C400412

Using the screw extractor, remove the 2 steering lock set bolts, upper steering column clamp and upper steering column bracket with switch assembly.


Hide 45020B 2.REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.
C399360N01
1.083,0.49 1.771,0.49 false 0.792,0.417 1.083,0.594 0.292,0.177 10 false SST

Using SST, strike a punch mark for drilling in the center of the steering lock set bolt.

SST
09622-00010  

NOTICE:

When striking the punch mark, in order to prevent impact force from being applied to the steering lock actuator assembly, do not use a normal center punch.



c.

Using a drill, drill a hole in the 2 steering lock set bolts and insert a screw extractor.


d.
C399361

Using the screw extractor, remove the 2 steering lock set bolts, upper steering column clamp and steering lock actuator assembly.


Hide 89650 3.REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY

Hide 45254B 4.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

Hide 89782 5.REMOVE TRANSPONDER KEY COIL (w/o Entry and Start System)

a.
C434153

Disengage the 2 claws and remove the transponder key coil.


Hide 84052 6.REMOVE UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C434154C01
0,0 0,0 false
V100135

Insert
V100136

Slide


Insert the key.


b.

Remove the un-lock warning switch assembly by releasing the 2 claws.

HINT:

Slide the un-lock warning switch assembly, in the direction shown by the arrow in the illustration, to remove it.



Hide 7.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.
C434155C01
0,0 0,0 false
V100135

Push
V100136

Pull


Turn the ignition switch to ACC.


b.

Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and pull out the ignition switch lock cylinder assembly.


Hide 84450 8.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C434156

Disengage the 2 claws and remove the ignition or starter switch assembly from the upper steering column bracket assembly.