Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _088019 HEATING / AIR CONDITIONING _0424497 BLOWER UNIT A

HEATING / AIR CONDITIONING  BLOWER UNIT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower unit removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
No. 1 blower damper servo sub-assembly Initialize servo motor (Air Conditioning System) DTCs are stored for HV Model:
(Click here)
for Gasoline Model:
(Click here)

PROCEDURE

Hide 1.REMOVE AIR CONDITIONER UNIT ASSEMBLY

Hide 87130D 2.REMOVE BLOWER ASSEMBLY

a.

for Manual Air Conditioning System:

i.
I115725

Disengage the guide.



b.

for Automatic Air Conditioning System:

i.
I115854

Disconnect the connector.



c.
I115726

Remove the 2 screws.


d.

Disengage the claws to remove the blower assembly.