Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0424557 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Avoid any impact to the blind spot monitor sensor.

·

Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



HINT:
·

The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector.

·

The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-2.2°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.



PROCEDURE

Hide 88172 1.INSTALL BLIND SPOT MONITOR SENSOR LH

a.

Install the blind spot monitor sensor LH with 3 new nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the connector.

NOTICE:

Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.



Hide 88162 2.INSTALL BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure described for the LH side.


Hide 3.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

Hide 4.INSTALL REAR BUMPER ASSEMBLY

Hide 5. BSM ECU DATE WRITE

NOTICE:

BSM ECU data write can only be performed when the beam axis adjustment value is able to be saved to the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT


Hide 6.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

NOTICE:

When BSM ECU data write can be performed, it is possible to omit the blind spot monitor beam axis confirmation.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT


SST
09870-60000  (09870-60010)
09870-60040