Home › General › MAINTENANCE › M15A-FKS DRIVE BELT
RM36W0E _V1 General _088300 MAINTENANCE _0424646 M15A-FKS DRIVE BELT A

MAINTENANCE  M15A-FKS DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

HINT:

When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.


a.
A426053C01
1.896,0.26 2.208,0.458 0.313,0.198 10 false *2 1.135,1.417 1.448,1.615 0.313,0.198 10 false *1 1.969,1.615 2.281,1.813 0.313,0.198 10 false *3
*1 Crankshaft Pulley Assembly
*2 Generator Assembly
*3 Compressor with Pulley Assembly


Set the fan and generator V belt onto each pulley as shown in the illustration.


b.

Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.


c.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.


Hide 51441C 2.INSTALL ENGINE UNDER COVER RH

Hide 51451A 3.INSTALL CENTER ENGINE UNDER COVER