Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH › 2020.03–2020.07
RM36W0E _52 Drivetrain _089426 CLUTCH _0424694 CLUTCH PEDAL SWITCH A

CLUTCH  CLUTCH PEDAL SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch pedal switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Parking support brake system (Click here)

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 55606 2.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 84520 3.REMOVE CLUTCH START SWITCH ASSEMBLY

a.
C435227

Disconnect the clutch start switch assembly connector.


b.

Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.

NOTICE:

To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.



Hide 4.REMOVE STEERING COLUMN ASSEMBLY

Hide 31453A 5.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN

Hide 6.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY

Hide 88280A 7.REMOVE CLUTCH SWITCH ASSEMBLY

a.
C434818

Loosen the nut and remove the clutch switch assembly from the clutch pedal support sub-assembly.