The transponder key ECU assembly blinks the security indicator light (combination meter assembly) when the immobiliser is set (no key is in the ignition key cylinder).
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Indicator | Security indicator light (combination meter assembly) | ON/OFF | - |
| Tester Display |
|---|
| Security Indicator |
Security indicator light can be turned on and off using the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H7 security indicator light (combination meter assembly) connector.
Disconnect the H74 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H74-8 (IND) - H7-7 (LP) | Always | Below 1 Ω |
| H74-8 (IND) or H7-7 (LP) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the H74 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H74-8 (IND) - Body ground | Key not in ignition key cylinder | Pulse generation |
| Key in ignition key cylinder | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG