Home › Engine / Hybrid System › CRUISE CONTROL › LANE TRACING ASSIST SYSTEM
RM36W0E _51 Engine / Hybrid System _088664 CRUISE CONTROL _0424999 LANE TRACING ASSIST SYSTEM J

CRUISE CONTROL  LANE TRACING ASSIST SYSTEM  Indicator Circuit  


DESCRIPTION

The forward recognition camera sends indicator illumination request signals to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle, and may cause a DTC to be output.


PROCEDURE

1.READ VALUE USING GTS (CAN BUS CHECK)
a.

Using the GTS, perform CAN bus diagnostics and check that there are no malfunctions in ECUs connected to the CAN communication system.

for HV Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM

for Gasoline Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM

CAN Bus Check
50007

Result:
Result Proceed to
CAN communication system is normal (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is not output) A
CAN communication system is malfunctioning (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is output) B



A

2.CHECK FOR DTCs (HEALTH CHECK)

B

2.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform a health check.


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

3.PERFORM ACTIVE TEST USING GTS (MULTI DISPLAY ALL (WHITE))

B

GO TO DTC CHART

3.PERFORM ACTIVE TEST USING GTS (MULTI DISPLAY ALL (WHITE))
a.

Using the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Multi Display All (White) Multi-information display (White display) ON Confirm that the vehicle is stopped with the ignition switch ON.
Body Electrical > Combination Meter > Active Test
Tester Display
Multi Display All (White)
50004 409 20

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY