This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.
The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1611 | ECU Malfunction | When one of the following conditions is met:
·
EEPROM status (Initial read) malfunction ·
CPU communication malfunction ·
ASIC output malfunction |
·
Rear television camera assembly optical axis (back camera position setting) ·
Steering angle setting ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Video Output Status | Output condition of video signal | OK or NG | OK: Output condition of video signal is normal
NG: Output condition of video signal is abnormal |
- |
| EEPROM Status (Initial read) | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal |
- |
| CPU Communication Status | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal |
- |
| Tester Display |
|---|
| Video Output Status |
| EEPROM Status (Initial read) |
| CPU Communication Status |
| Result | Proceed to |
|---|---|
| OK is displayed for all items | A |
| NG is displayed for EEPROM status (Initial read) | |
| NG is displayed for items other than EEPROM status (Initial read) | B |
A
B
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Rear television camera assembly optical axis adjustment (back camera position setting).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs by following the prompts on the GTS screen.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs by following the prompts on the GTS screen.
If DTC C1611 is output, perform the procedure to register the vehicle information into the rear television camera assembly .
If DTC C1611 is still output after performing the procedure to register the vehicle information into the rear television camera assembly 3 times, replace the rear television camera assembly .
| Result | Proceed to |
|---|---|
| DTC C1611 is not output | A |
| DTC C1611 is output | B |
A
B