This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1694 | Steering Angle Initialization Incomplete | Maximum steering angle has not been memorized (steering angle setting is incomplete) | ·
Steering angle setting ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs by following the prompts on the GTS screen.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs by following the prompts on the GTS screen.
If DTC C1694 is output, perform the steering angle setting again.
If DTC C1694 is still output after performing the steering angle setting 3 times, replace the rear television camera assembly.
| Result | Proceed to |
|---|---|
| DTC C1694 is not output | A |
| DTC C1694 is output | B |
A
B