This DTC is stored when the rear television camera assembly judges that it has an internal CAN malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | CAN communication failure (message registry) | Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Clear the DTCs by following the prompts on the GTS screen.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs by following the prompts on the GTS screen.
If DTC U1000 is not output again when rechecking for DTCs, it may have been stored due to a temporary CAN malfunction.
If DTC U1000 is output frequently, duplicate the problem symptoms and perform the inspection again, even if the DTC was not output when rechecking for DTCs.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| DTC U1000 is output | A |
| DTC U1000 is not output | B |
| None of the above conditions are met | C |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
C