Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0425251 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U023387  Lost Communication with Side Obstacle Detection Control Module "B" Missing Message  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH (A) judges that there is a communication problem with the blind spot monitor sensor LH (B).

DTC No. Detection Item DTC Detection Condition Trouble Area
U023387 Lost Communication with Side Obstacle Detection Control Module "B" Missing Message The blind spot monitor sensor RH (A) cannot receive signals from the blind spot monitor sensor LH (B)
·

Blind spot monitor sensor LH (B)

·

Blind spot monitor sensor RH (A)

·

Harness or connector



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


HINT:
·

Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

·

Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Reconnect the cable to the negative (-) auxiliary battery terminal.


b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check for DTCs.

Body Electrical > Blind Spot Monitor "A" > Trouble Codes
50001 461

Result:
Result Proceed to
DTC U023387 is output A
No DTCs are output B



A

2.REPLACE BLIND SPOT MONITOR SENSOR LH (B)

B

2.REPLACE BLIND SPOT MONITOR SENSOR LH (B)

NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Blind Spot Monitor "A" > Clear DTCs
50002 461

Result:
Proceed to
NEXT



NEXT

4.CHECK DTC OUTPUT
4.CHECK DTC OUTPUT
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor "A" > Trouble Codes
50001 461

Result:
Result Proceed to
DTC U023387 is output A
No DTCs are output B



A

B

END (BLIND SPOT MONITOR SENSOR LH (B) WAS DEFECTIVE)