Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.03–2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0425342 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C006328  Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure  C00632A  Yaw Rate Sensor Signal Stuck In Range  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor.

When the skid control ECU (brake booster with master cylinder assembly) detects improper installation of the yaw rate and acceleration sensor (airbag sensor assembly) or an abnormality in the difference between the yaw rate sensor value and the control value estimated based on the acceleration sensor, steering sensor and speed sensor signals, DTC C006328 and/or C00632A is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C006328 Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure With the vehicle stationary, the yaw rate sensor output value is not 0 deg/s.
·

Yaw rate sensor (airbag sensor assembly) installed improperly

·

Yaw rate sensor (airbag sensor assembly


Brake
C00632A Yaw Rate Sensor Signal Stuck In Range A yaw rate sensor stuck malfunction status continues.
·

Yaw rate sensor (airbag sensor assembly) installation

·

Yaw rate sensor (airbag sensor assembly)


Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform "Calibration" after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.READ VALUE USING GTS (YAW RATE SENSOR)
a.

Select the Data List on the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Yaw Rate Sensor Value Yaw rate and acceleration sensor (airbag sensor assembly) Min.: -128° /s
Max.: 127° /s
Vehicle stopped: 0° /s
Turning right: -128 to 0° /s
Turning left: 0 to 127° /s
-
Chassis > Brake > Data List
Tester Display
Yaw Rate Sensor Value
50003 435 29

b.

Check the yaw rate sensor output value displayed on the GTS.


Result:
Result Proceed to
NG (The yaw rate sensor (airbag sensor assembly) output value is 0 deg/s when the vehicle is stationary, but the value fluctuates when turning.) A
NG (The yaw rate sensor (airbag sensor assembly) output value is not 0 deg/s when the vehicle is stationary.) B
OK C



A

2.CHECK AIRBAG SENSOR ASSEMBLY

B

C

2.CHECK AIRBAG SENSOR ASSEMBLY
a.

Turn the ignition switch off.


b.

Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.

The yaw rate and acceleration sensor (airbag sensor assembly) is not tilted.



Result:
Proceed to
OK
NG



OK

NG