Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMC Made) › 2020.07–2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0430772 REAR AXLE HUB(for TMC Made) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMC Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle hub removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:
for HV Model
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION (for HV Model)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISABLE BRAKE CONTROL (for HV Model)

Hide 3.REMOVE REAR WHEEL

Hide 42431D 4.REMOVE BRAKE DRUM

Hide 89516D 5.DISCONNECT SKID CONTROL SENSOR WIRE

a.
C428563C01
1.333,1.333 1.583,1.333 true 1.135,1.26 1.333,1.5 0.198,0.24 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disconnect the skid control sensor wire connector from the rear axle hub and bearing assembly.

NOTICE:

Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



Hide 42450B 6.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C428562

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.