31321
1.INSTALL CLUTCH PEDAL PAD
Install the clutch pedal pad to the clutch pedal sub-assembly.
31453B
2.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSHING
Install a new clutch master cylinder push rod clevis bushing to the clutch pedal sub-assembly.
Install the clutch master cylinder push rod clevis bushing from the left side of the vehicle.
|
MP Grease |
Apply MP grease to the inside of the clutch master cylinder push rod clevis bushing.
31324A
3.INSTALL CLUTCH PEDAL SHAFT COLLAR
Install the clutch pedal shaft collar to the clutch pedal sub-assembly.
|
MP Grease |
Apply MP grease to both sides of 2 new clutch pedal bushings.
Install the 2 clutch pedal bushings to the clutch pedal sub-assembly.
31301P
4.INSTALL CLUTCH PEDAL TURNOVER BUSH (except 1KR-FE)
|
MP Grease |
Apply MP grease to the inside of the clutch pedal turnover bushing.
Install the clutch pedal turnover bushing to the clutch pedal sub-assembly.
31353
5.INSTALL CLUTCH PEDAL SPRING HOLDER (except 1KR-FE)
|
MP Grease |
Apply MP grease to the contact surface of the clutch pedal spring holder.
Install the clutch pedal spring holder to the clutch pedal support sub-assembly.
31301
6.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
Install the clutch pedal sub-assembly to the clutch pedal support sub-assembly with the bolt.
Install the bolt from the right side of the vehicle.
Turn the nut while holding the bolt.
31301A
7.INSTALL CLUTCH PEDAL SPRING (except 1KR-FE)
Move the clutch pedal sub-assembly to the full stroke position.
Install the clutch pedal spring to the clutch pedal sub-assembly and clutch pedal bracket sub-assembly.
88280A
8.INSTALL CLUTCH SWITCH ASSEMBLY
9.INSTALL CLUTCH PEDAL SUPPORT ASSEMBLY
Install the clutch pedal support assembly to the vehicle body with the 4 nuts.
Engage the 2 clamps to connect the wire harness to the clutch pedal support assembly.
Connect the clutch switch assembly connector.
31453A
10.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
|
MP Grease |
Apply MP grease to the clevis pin.
Connect the clutch master cylinder assembly to the clutch pedal sub-assembly with the master cylinder push rod clevis with hole pin.
Install the clevis pin from the left side of the vehicle.
Install a new clip to the master cylinder push rod clevis with hole pin.
84520
11.INSTALL CLUTCH START SWITCH ASSEMBLY
12.INSTALL STEERING COLUMN ASSEMBLY
13.INSPECT CLUTCH PEDAL
88280A
14.INSPECT CLUTCH START SYSTEM
15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART