Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for LHD) › from 2020.07
RM36W0E _52 Drivetrain _089426 CLUTCH _0430795 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake booster assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking Assist Monitor System (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 44610 1.REMOVE BRAKE BOOSTER ASSEMBLY

Hide 31434E 2.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE

a.
C437874

Slide the hose clip and disconnect the No. 1 clutch reservoir hose from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31481 3.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C437875

Using a 10 mm union nut wrench, disconnect the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31453A 4.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN

Hide 31410 5.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C437876

Remove the 2 nuts and clutch master cylinder assembly from the vehicle body.


b.

Remove the clutch master cylinder gasket from the clutch master cylinder assembly.