Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 1KR-FE) › from 2020.07
RM36W0E _52 Drivetrain _087547 DRIVE SHAFT / PROPELLER SHAFT _0430982 FRONT DRIVE SHAFT ASSEMBLY(for 1KR-FE) A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 1KR-FE)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front drive shaft assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment Calibration
·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Suspension, tires, etc.
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEELS

Hide 51451A 2.REMOVE CENTER ENGINE UNDER COVER

Hide 51442C 3.REMOVE ENGINE UNDER COVER LH

Hide 51441C 4.REMOVE ENGINE UNDER COVER RH

Hide 5.DRAIN MANUAL TRANSAXLE OIL

Hide 43502H 6.REMOVE FRONT AXLE SHAFT NUT

a.
C439738N01
2.021,2.021 2.26,2.021 2.26,2.021 2.5,1.448 false 1.708,1.938 2.156,2.125 0.448,0.188 10 false SST

Using SST and a hammer, release the staked part of the front axle shaft nut.

SST
09930-00010  

NOTICE:

Loosen the staked part of the front axle shaft nut completely, otherwise the threads of the drive shaft may be damaged.



b.

While applying the brakes, remove the front axle shaft nut.


Hide 89543 7.SEPARATE FRONT SPEED SENSOR

Hide 45047 8.SEPARATE TIE ROD END SUB-ASSEMBLY

Hide 48810 9.SEPARATE FRONT STABILIZER LINK ASSEMBLY

Hide 48069 10.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

Hide 43420 11.SEPARATE FRONT DRIVE SHAFT ASSEMBLY

Hide 43420 12.REMOVE FRONT DRIVE SHAFT ASSEMBLY

a.
C439743N01
2.104,1.625 1.385,1.885 1.385,1.885 1.927,1.271 true 1.083,1.813 1.542,2.01 0.458,0.198 10 false SST

Using SST, remove the front drive shaft assembly.

SST
09520-01011  
09520-20010  (09521-02010, 09521-02040, 09521-02060)

NOTICE:
·

Do not damage the front drive shaft oil seal.

·

Do not damage the front axle inboard joint boot.

·

Do not drop the front drive shaft assembly.




Hide 43420G 13.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING

a.
C264437

Using a screwdriver, remove the front drive shaft hole snap ring.