Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › from 2020.07
RM36W0E _53 Suspension _090947 TIRE PRESSURE MONITORING _0430996 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  INSTALLATION  


PROCEDURE

Hide 897B0A 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.

Connect the connector.


b.

Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 64730B 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>INSTALLATION