Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › from 2020.07
RM36W0E _53 Suspension _090947 TIRE PRESSURE MONITORING _0430996 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning ECU and receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.

·

Tire pressure warning function


for Initialization:
(Click here)
for Registration:
(Click here)

NOTICE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 64730B 1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>REMOVAL


Hide 897B0A 2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C439132

Remove the bolt.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the tire pressure warning ECU and receiver.