Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2020.07
RM36W0E _58 Vehicle Interior _087985 METER / GAUGE / DISPLAY _0420292 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Oil Pressure Switch Circuit  


DESCRIPTION

The combination meter assembly and engine oil pressure switch assembly are connected via direct line. The combination meter assembly determines the engine oil pressure based on the engine oil pressure switch signal.

HINT:
·

The combination meter assembly receives engine speed data signal from the ECM via CAN communication in order to output warnings.

·

The combination meter assembly operates the following to output oil pressure warnings:

(a)

Engine oil pressure warning message on multi-information display

(b)

Engine oil pressure warning buzzer




WIRING DIAGRAM

E436632E02
1.5,1.156 2.104,1.417 0.604,0.26 10 false ECM 0.635,2.865 3.219,3.229 2.583,0.365 10 false Engine Oil Pressure Switch Assembly 0.646,2.667 1.104,2.865 0.458,0.198 10 false D73 4.833,2.854 5.302,3.125 0.469,0.271 10 false H7 4.833,3.042 7.125,3.24 2.292,0.198 10 false Combination Meter Assembly 4.938,2.094 5.552,2.292 0.615,0.198 10 false S 4.688,2.104 5,2.302 0.313,0.198 10 false 23 5.635,1.74 6.25,1.938 0.615,0.198 10 false 12 V 2.375,2.083 2.688,2.281 0.313,0.198 10 false 1 0.563,3.448 2.802,3.688 2.24,0.24 10 false : CAN Communication Line 2.177,2.115 2.333,2.313 0.156,0.198 10 false S

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

The following troubleshooting procedure is based on the assumption that the SFI system is normal. Confirm that the SFI system is not malfunctioning before performing the following procedure.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
a.

Inspect the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>1KR-FE (LUBRICATION)>OIL PRESSURE SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the H7 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H7-23 (S) - D73-1 (S) Always Below 1 Ω
H7-23 (S) or D73-1 (S) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR