77277R
1.INSTALL FUEL TANK FILLER PIPE PROTECTOR
Engage the 4 clamps to install a new fuel tank filler pipe protector to the fuel tank filler pipe sub-assembly.
Engage the 4 claws.
77218A
2.INSTALL NO. 3 FUEL TANK FILLER PIPE SUPPORT
Engage the 3 clamps to install the No. 3 fuel tank filler pipe support to the fuel tank filler pipe sub-assembly.
77216A
3.INSTALL NO. 1 FUEL TANK FILLER PIPE SUPPORT
Engage the 3 clamps to install the No. 1 fuel tank filler pipe support to the fuel tank filler pipe sub-assembly.
77217A
4.INSTALL NO. 2 FUEL TANK FILLER PIPE SUPPORT
Engage the 2 claws to install the No. 2 fuel tank filler pipe support to the fuel tank filler pipe sub-assembly.
77027B
5.INSTALL NO. 1 FUEL EMISSION TUBE SUB-ASSEMBLY
Engage the clamp to install the No. 1 fuel emission tube sub-assembly to the fuel tank assembly.
77209F
6.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the clamp to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77100U
7.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
8.INSTALL FUEL TANK FILLER PIPE SUB-ASSEMBLY
Engage the locations shown in the illustration, and engage the fuel tank filler pipe sub-assembly to the vehicle body.
Install the bolt.
77209F
9.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>1KR-FE (FUEL)>FUEL SYSTEM>PRECAUTION
77027B
10.CONNECT NO. 1 FUEL EMISSION TUBE SUB-ASSEMBLY
Connect the No. 1 fuel emission tube sub-assembly to the fuel pipe and slide the clip to secure it.
Click hereEngine / Hybrid System>1KR-FE (FUEL)>FUEL SYSTEM>PRECAUTION
77606
11.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Install the No. 1 fuel tank protector sub-assembly to the fuel tank assembly with the 3 clips.
17410
12.INSTALL FRONT EXHAUST PIPE ASSEMBLY
77310A
13.INSTALL FUEL TANK CAP ASSEMBLY
77020A
14.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
65638
15.INSTALL REAR WHEEL HOUSE LINER LH
Install the rear fender liner with the grommet and 5 clips.
Install the 2 screws.
16.INSTALL WHEEL ASSEMBLY
17.ADD FUEL