Home › Engine / Hybrid System › 1KR-FE (FUEL) › FUEL INJECTOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _090956 1KR-FE FUEL _0431074 FUEL INJECTOR A

1KR-FE FUEL  FUEL INJECTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 82121 5.DISCONNECT ENGINE WIRE

a.
A426325

Disconnect the 6 fuel injector assembly connectors.


b.

Disengage the clamp.


Hide 23901 6.DISCONNECT FUEL TUBE SUB-ASSEMBLY

a.
A426326

Disconnect the fuel tube sub-assembly from the fuel delivery pipe.

Click hereEngine / Hybrid System>1KR-FE (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 23814B 7.REMOVE FUEL DELIVERY PIPE

a.
A426327

Remove the 2 bolts and fuel delivery pipe with the 6 fuel injector assemblies and 2 fuel pipe insulators.

NOTICE:

Do not drop the fuel injector assemblies when removing the fuel delivery pipe.



Hide 23845C 8.REMOVE FUEL PIPE INSULATOR

a.
A426328

Remove the 2 fuel pipe insulators from the fuel delivery pipe.


Hide 23250 9.REMOVE FUEL INJECTOR ASSEMBLY

a.
A426329

Pull the 6 fuel injector assemblies out of the fuel delivery pipe.


b.

Remove the O-ring from each fuel injector assembly.


c.

For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector assembly.

NOTICE:

Protect the fuel injector assemblies by covering them with plastic bags.



Hide 23291 10.REMOVE INJECTOR VIBRATION INSULATOR

a.
A426330

Remove the 6 injector vibration insulators from the cylinder head sub-assembly.