1.DRAIN ENGINE COOLANT
2.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
17650G
3.REMOVE DUTY VACUUM SWITCHING VALVE
25601
4.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
Remove the 2 bolts and 2 nuts to remove the NO.1 EGR pipe sub-assembly.
Remove the EGR pipe gasket from the NO.1 EGR pipe sub-assembly.
Remove the EGR pipe gasket from the intake manifold.
5.REMOVE EGR VALVE WITH COOLER ASSEMBLY
Disconnect the EGR valve assembly connector.
| *1 | No. 2 Water By-pass Hose Assembly |
| *2 | Water Hose Sub-assembly |
| *3 | No. 4 Water By-pass Hose Assembly |
Slide the clip and disconnect the No. 2 water by-pass hose assembly from the EGR valve assembly.
Slide the clip and disconnect the water hose sub-assembly from the EGR cooler assembly.
Slide the clip and disconnect the No. 4 water by-pass hose assembly from the EGR cooler assembly.
Disengage the wire harness clamp and disconnect the engine wire.
Remove the 2 bolts, 2 nuts and EGR valve assembly with the EGR cooler assembly from the EGR valve bracket and cylinder head sub-assembly.
Remove the EGR valve gasket from the EGR cooler assembly.
25620
6.REMOVE EGR VALVE ASSEMBLY
Slide the clip and disconnect the No. 3 water by-pass hose from the EGR valve assembly.
Remove the 2 nuts and EGR valve assembly from the EGR cooler assembly.
Remove the No. 1 EGR cooler gasket from the EGR valve assembly.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the EGR valve assembly.
If a stud bolt is deformed or the threads are damaged, replace it.