Home › Engine / Hybrid System › 1KR-FE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › from 2020.07
RM36W0E _51 Engine / Hybrid System _091035 1KR-FE ENGINE MECHANICAL _0431329 REAR CRANKSHAFT OIL SEAL A

1KR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 31250 1.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 2.REMOVE FLYWHEEL SUB-ASSEMBLY

a.

Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat, level surface.

NOTICE:
·

Using height adjustment attachments and plate lift attachments, place the engine assembly horizontally.

·

Using an engine sling device and engine lift, secure the engine assembly before servicing.




b.

Using SST, hold the crankshaft pulley.

SST
09960-10010  (09962-01000, 09963-01000)


c.
A322227

Remove the 6 bolts and flywheel sub-assembly from the crankshaft.


Hide 11381A 3.REMOVE REAR ENGINE OIL SEAL

a.

Using a knife, cut off the lip of the rear engine oil seal.


b.
A322228C01
1.104,1.198 1.281,1.729 true 1.229,1.75 1.438,1.958 0.208,0.208 10 true *a
*a Protective Tape


Using a screwdriver, pry out the rear engine oil seal.

NOTICE:

After removal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.