Home › General › MAINTENANCE › 1KR-FE DRIVE BELT › from 2020.07
RM36W0E _V1 General _088300 MAINTENANCE _0431334 1KR-FE DRIVE BELT A

MAINTENANCE  1KR-FE DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

HINT:

When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.


a.
A470295

Set the fan and generator V belt onto each pulley as shown in the illustration.


b.
A329388C01
0.688,1.906 0.469,1.729 false 0.771,1.844 0.969,2.031 0.198,0.188 10 true *a
*a 4 mm Hexagon Wrench


Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 4 mm hexagon wrench.


c.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.


Hide 51441C 2.INSTALL ENGINE UNDER COVER RH

Hide 51451A 3.INSTALL CENTER ENGINE UNDER COVER