Home › Engine / Hybrid System › 1KR-FE (LUBRICATION) › LUBRICATION SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091047 1KR-FE LUBRICATION _0431393 LUBRICATION SYSTEM G

1KR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL

a.

Check engine oil level.

i.

Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

·

If low quality oil or oil of an inappropriate viscosity is used.

·

When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.

·

When leaving the idling for a long time, or when driving frequently through heavy traffic.


When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.




b.

Check engine oil quality.

i.

Check the oil for deterioration, water contamination, discoloration and thinning.

If the quality is visibly poor, replace the oil.



Hide 2.CHECK OIL PRESSURE

a.

Remove the engine oil pressure switch (See page Engine / Hybrid System>1KR-FE (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL).


b.
A191919

Install the oil pressure gauge with the adapter.


c.

Start the engine.


d.

Warm up the engine.


e.

Check the oil pressure.

Standard:
Engine rpm Oil Pressure
840 rpm 30 kPa (0.3 kgf/cm2, 4.3 psi) or more
3000 rpm 200 kPa (2.0 kgf/cm2, 28.4 psi) or more


If the oil pressure is not as specified, repair the lubrication system.


f.

Remove the oil pressure gauge with the adapter.


g.

Install the engine oil pressure switch (See page Engine / Hybrid System>1KR-FE (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION).


h.

Inspect for engine oil leak.