Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › ACCELERATOR PEDAL › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431472 ACCELERATOR PEDAL A

1KR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

for LHD:

i.

Install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



ii.

Connect the accelerator pedal sensor assembly connector.



b.

for RHD:

i.

Install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



ii.

Connect the accelerator pedal sensor assembly connector.



Hide 55606 2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY