Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › KNOCK SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431477 KNOCK SENSOR A

1KR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

a.
A426017C01
1.354,2.625 1.667,2.781 0.313,0.156 10 false *a 2.531,3.688 2.844,3.844 0.313,0.156 10 false *c 2.708,3.229 3.021,3.385 0.313,0.156 10 false *b
*a Top
*b Right Side of Vehicle
*c 30 to 50°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.