Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR (for Sensor 1) › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431478 HEATED OXYGEN SENSOR(for Sensor 1) A

1KR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A468360C01
1.844,1.104 2.25,1.104 true 0.531,2.958 0.781,3.146 0.25,0.188 10 false *a 2.271,1.021 2.646,1.26 0.375,0.24 10 true SST 1.719,2.979 1.969,3.167 0.25,0.188 10 false *b
*a SST Fulcrum Length
*b Torque Wrench Fulcrum Length


Using SST, install the heated oxygen sensor to the exhaust manifold.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.

Engage the 2 wire harness clamps.


c.

Connect the heated oxygen sensor connector.