Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR (for Sensor 2) › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431479 HEATED OXYGEN SENSOR(for Sensor 2) A

1KR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89465A 1.INSTALL HEATED OXYGEN SENSOR

a.
A470306C01
1.49,0.469 1.719,0.24 1.719,0.24 1.938,0.24 true 1.688,1.865 1.948,2.094 0.26,0.229 10 true *a 1.948,0.125 2.344,0.344 0.396,0.219 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the heated oxygen sensor to the front exhaust pipe assembly..

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.
A468362

Engage the 2 wire harness clamps.

NOTICE:

Make sure the white tube is between the wires.



c.

Connect the heated oxygen sensor connector.