Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431746 SFI SYSTEM C

1KR-FE ENGINE CONTROL  SFI SYSTEM  P222611  Barometric Pressure Sensor "A" Circuit Short to Ground  P222615  Barometric Pressure Sensor "A" Circuit Short to Battery or Open  


DESCRIPTION

To detect atmospheric pressure, the atmospheric pressure sensor is built into the ECM. According to changes in the atmospheric pressure, the ECM corrects the fuel injection volume, timing, and duration in order to optimize engine combustion.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory DTC Output from Priority
P222611 Barometric Pressure Sensor "A" Circuit Short to Ground Atmospheric pressure sensor malfunction (3 trip detection logic). ECM Comes on DTC stored Engine B
P222615 Barometric Pressure Sensor "A" Circuit Short to Battery or Open Atmospheric pressure sensor malfunction (3 trip detection logic). ECM Comes on DTC stored Engine B

CONFIRMATION DRIVING PATTERN

DTC P222611 and P222615 are detected when the engine idles for 15 seconds.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, perform idle learning.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


PROCEDURE

1.CLEAR DTC

Pre-procedure1

a.

None.


Procedure1

b.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

Result:
Proceed to
NEXT


Post-procedure1

c.

Turn the ignition switch off and wait for at least 30 seconds.



NEXT

2.CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P222611 OR P222615)
2.CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P222611 OR P222615)

Pre-procedure1

a.

Start the engine.


b.

Allow the engine to idle for 15 seconds or more.


Procedure1

c.

Read the pending DTCs.

Powertrain > Engine > Trouble Codes
50001 372
Result:
Result Proceed to
Only P222611 or P222615 is output A
P222611 or P222615 and other DTCs are output B


HINT:

If any DTCs other than P222611 or P222615 are output, troubleshoot those DTCs first.



Post-procedure1

d.

None.



A

B

GO TO DTC CHART