Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431746 SFI SYSTEM C

1KR-FE ENGINE CONTROL  SFI SYSTEM  P21382B  Throttle/Pedal Position Sensor/Switch "D"/"E" Voltage Correlation Signal Cross Coupled  


DESCRIPTION

Refer to DTC P212012.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>P212012

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory DTC Output from Priority
P21382B Throttle/Pedal Position Sensor/Switch "D"/"E" Voltage Correlation Signal Cross Coupled The difference in output between accelerator pedal position sensors 1 and 2 is outside the threshold range (1 trip detection logic).
·

Accelerator pedal sensor assembly

·

Accelerator pedal sensor assembly circuit


Comes on DTC stored Engine A

WIRING DIAGRAM

CONFIRMATION DRIVING PATTERN

DTC P21382B is detected when the ignition switch is ON or engine running.

CAUTION / NOTICE / HINT

NOTICE:

If any DTCs related to the crankshaft position sensor, throttle position sensor, accelerator pedal sensor assembly, manifold absolute pressure sensor and camshaft position sensor are output simultaneously, inspect the VC circuit of each component.


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - ACCELERATOR PEDAL SENSOR ASSEMBLY)

Pre-procedure1

a.

Disconnect the ECM connector.


b.

Disconnect the accelerator pedal sensor assembly connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A55-49 (VCPA) - A62-4 (VCPA) Always Below 1 Ω
A55-47 (VPA) - A62-6 (VPA) Always Below 1 Ω
A55-48 (EPA) - A62-5 (EPA) Always Below 1 Ω
A55-52 (VCP2) - A62-1 (VCP2) Always Below 1 Ω
A55-50 (VPA2) - A62-3 (VPA2) Always Below 1 Ω
A55-51 (EPA2) - A62-2 (EPA2) Always Below 1 Ω
A55-49 (VCPA) or A62-4 (VCPA) - Body ground Always 10 kΩ or higher
A55-47 (VPA) or A62-6 (VPA) - Body ground Always 10 kΩ or higher
A55-48 (EPA) or A62-5 (EPA) - Body ground Always 10 kΩ or higher
A55-52 (VCP2) or A62-1 (VCP2) - Body ground Always 10 kΩ or higher
A55-50 (VPA2) or A62-3 (VPA2) - Body ground Always 10 kΩ or higher
A55-51 (EPA2) or A62-2 (EPA2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG


Post-procedure1

d.

None.



OK

REPLACE ACCELERATOR PEDAL SENSOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR