63310
1.REMOVE ROOF HEADLINING ASSEMBLY
75552
2.REMOVE ROOF DRIP SIDE FINISH MOULDING
63201M
3.REMOVE NO. 1 ROOF WINDOW GLASS SUB-ASSEMBLY
Be careful not to damage the No. 1 roof window glass sub-assembly as the roof window clips are installed to the No. 1 roof window glass sub-assembly.
|
Protective Tape |
Apply protective tape to the area around the installation position of the No. 1 roof window glass sub-assembly on the vehicle body to prevent it from being scratched.
Using a knife, cut off the roof window upper moulding as shown in the illustration.
| *1 | No. 1 Roof Window Glass Sub-assembly | *2 | Roof Window Upper Moulding |
| *a | Cut Area | - | - |
Do not damage the body with the knife.
After partially disconnecting the part, pull by hand to finish removing it.
| *1 | Windshield Outside Moulding |
| *2 | No. 1 Roof Window Glass Sub-assembly |
|
Protective Tape |
Turn back the windshield outside moulding lip and hold it with protective tape.
Pass a piano wire between the vehicle body and No. 1 roof window glass sub-assembly from the interior.
| *a | Piano Wire | *b | Roof Window Clip |
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
Cut the adhesive by pulling the piano wire around the No. 1 roof window glass sub-assembly.
When separating the No. 1 roof window glass sub-assembly, be careful not to damage the paint or interior and exterior ornaments.
Using suction cups, disengage the roof window clips to remove the No. 1 roof window glass sub-assembly.
Be careful not to drop the No. 1 roof window glass sub-assembly.
Leave as much adhesive on the vehicle body as possible when removing the No. 1 roof window glass sub-assembly.