Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
87945
2.REMOVE OUTER MIRROR COVER
3.REMOVE OUTER MIRROR LOWER COVER
Remove the screw.
Disengage the claws to remove the outer mirror lower cover.
81740
4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
87948
5.REMOVE OUTER MIRROR HOLE COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the outer mirror hole cover.
87966
6.REMOVE OUTER MIRROR RETRACTOR
Remove the vinyl tape.
Remove the 2 clips.
| *a | Cut here |
Cut the wire harness at the position as shown in the illustration.
Disengage the guides to remove the gasket.
Remove the 4 screws and base.
Remove the 3 screws.
Disengage the guide to separate the power unit assembly.
Disconnect the connector to remove the power unit assembly.
Remove the 3 screws and outer mirror retractor.
Disconnect the connector to remove the wire harness from outer mirror retractor.