Home › Brake › BRAKE (REAR) › REAR BRAKE (for TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _089429 BRAKE (REAR) _0432132 REAR BRAKE(for TMMF Made) A

BRAKE (REAR)  REAR BRAKE(for TMMF Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 58903A 3.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY

Hide 4.REMOVE REAR WHEEL

Hide 5.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 6.LOOSEN PARKING BRAKE CABLE

a.
C430601C03
2.99,1.021 2.667,1.208 true 3.01,0.917 3.24,1.115 0.229,0.198 10 true *1
*1 No. 1 Wire Adjusting Nut


Loosen the No. 1 wire adjusting nut

NOTICE:

Do not reuse the loosened No. 1 wire adjusting nut.



Hide 42431D 7.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

C437950

a.

Remove the hole plug.


b.
C437951N01
1.635,1.344 1.896,1.281 true 1.281,1.25 1.604,1.458 0.323,0.208 10 true SST

Insert SST through the hole in the backing plate, pull the parking brake shoe lever toward the rear of the vehicle and remove the rear brake drum sub-assembly.

SST
09921-00011  


Hide 04495 8.REMOVE REAR BRAKE SHOE KIT

a.
C437952N01
1.115,0.823 1.375,1.333 true 1.417,1.25 1.771,1.479 0.354,0.229 10 true SST

Using SST, remove the return shoe spring.

SST
09703-30011  

NOTICE:

Do not damage the wheel cylinder boot.



b.
C437953N01
1.573,1.854 1.813,1.948 false 1.844,1.854 2.188,2.031 0.344,0.177 10 false SST

Using SST, remove the tension spring.

SST
09703-30011  


c.
C437954

Using pliers, remove the shoe hold down spring, shoe hold down pin and front brake shoe.

NOTICE:

Do not disassemble the strut set, and be careful not to damage or bend any of the components.



d.
C437955

Using pliers, remove the shoe hold down spring, shoe hold down pin and rear brake shoe.


e.
C130273

Using needle-nose pliers, disconnect the parking brake cable from the parking brake shoe lever.


Hide 47570 9.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY

a.
C437956

Using a union nut wrench 10 mm, separate the brake tube from the rear wheel brake cylinder assembly.

HINT:

Use a container to catch the brake fluid.



b.

Remove the 2 bolts and rear wheel brake cylinder assembly.