Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
04495
1.INSTALL REAR BRAKE SHOE KIT
|
High Temperature Grease |
Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.
Using needle-nose pliers, connect the parking brake cable onto the parking brake shoe lever.
Using pliers, install the rear brake shoe, pin and shoe hold down spring.
|
High Temperature Grease |
Apply high temperature grease to the adjusting bolt.
| *a | Inside of Vehicle |
| *b | Outside of Vehicle |
Install the parking brake shoe strut set as shown in the illustration.
Using pliers, install the front brake shoe, pin and shoe hold down spring.
Using SST, install the tension spring.
Using SST, install the return shoe spring.
Do not damage the wheel cylinder boot.
2. CHECK REAR DRUM BRAKE INSTALLATION
Check that each part is installed properly.
| *A | for LH Side | *B | for RH Side |
|
Front of the Vehicle | - | - |
Measure the rear brake drum sub-assembly inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.
0.6 mm (0.024 in.)
There should be no oil or grease adhering to the friction surfaces of the shoe lining or the rear brake drum sub-assembly.
42431D
3.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
Install the rear brake drum sub-assembly.
4.BLEED BRAKE LINE
5.BLEED CLUTCH LINE (for Manual Transmission)
for C551:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM (for C551)>BLEEDING
for EC6E
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM (for EC6E)>BLEEDING
6.ADJUST REAR DRUM BRAKE SHOE CLEARANCE
Do not use screwdrivers or any other tools to rotate the adjuster.
Press the brake pedal 30 times (not the parking brake). The clearance between the brake shoes and drum will be adjusted automatically.
7.INSTALL REAR WHEEL
8.ADJUST PARKING BRAKE LEVER TRAVEL