Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _089428 BRAKE (FRONT) _0432145 FRONT BRAKE(for TMMF Made) G

BRAKE (FRONT)  FRONT BRAKE(for TMMF Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the front disc brake cylinder assembly and front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

C129737C01
2.01,0.896 2.25,0.573 false 2.292,0.469 2.688,0.646 0.396,0.177 10 false *a
*a Ruler


a.

Using a ruler, measure the pad lining thickness.

Standard thickness:
Front Brake 14 inch:

11.3 mm (0.445 in.)

Front Brake 15 inch:

11.5 mm (0.453 in.)


Minimum thickness:

1.5 mm (0.0591 in.)


HINT:
·

If a front disc brake pad lining thickness is less than the minimum thickness, replace the front disc brake pads.

·

Be sure to check the front disc thickness when replacing the front disc brake pads with new ones.




Hide 3.INSPECT DISC THICKNESS

C437931C01
0.688,1.813 0.979,1.573 true 0.479,1.708 0.792,1.865 0.313,0.156 10 false *a
*a Micrometer


a.

Using a micrometer, measure the disc thickness.

Standard thickness:

22.0 mm (0.866 in.)


Minimum thickness:

19.0 mm (0.748 in.)


HINT:

If the front disc thickness is less than the minimum thickness, replace the front disc.



Hide 4.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB (for TMMF Made)>ON-VEHICLE INSPECTION


b.

Temporarily install the front disc with the 5 hub nuts.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


c.
C437932C01
2.552,1.667 2.333,1.427 false 2.583,1.594 2.896,1.75 0.313,0.156 10 false *a
*a Dial Indicator


Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


NOTICE:

Keep the magnet of the dial indicator away from the front speed sensor.


HINT:

If the runout exceeds the maximum value, change the installation position of the front disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.