Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB (for TMMF Made) › 2020.07–2021.11
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0430758 FRONT AXLE HUB(for TMMF Made) G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for TMMF Made)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

The following procedure is for the LH side.

·

Use the same procedure for the RH side and LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 3.REMOVE FRONT DISC

Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C427803

Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly.

Maximum Looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.



HINT:

If the looseness exceeds the maximum, replace the front axle hub sub-assembly.



Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
C427804

Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

Maximum Runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.



HINT:

If the runout exceeds the maximum, replace the front axle hub sub-assembly.



Hide 7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 8.INSTALL FRONT WHEEL