Home › Engine / Hybrid System › 1KR-FE (STARTING) › STARTER (w/ Stop And Start System) › from 2020.07
RM36W0E _51 Engine / Hybrid System _091207 1KR-FE STARTING _0432155 STARTER(w/ Stop And Start System) A

1KR-FE STARTING  STARTER(w/ Stop And Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the wire harness clamp bracket to the starter assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the starter assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


c.

Engage the wire harness clamp.


d.

Connect the starter assembly connector.


e.

Connect terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


f.

Close the terminal cap.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A470095

Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block and while pushing it along the cylinder block, engage the claw with the cylinder block.

NOTICE:
·

Make sure that the claw makes a click sound, indicating a tight fit.

·

Replace the flywheel housing side cover with a new one if it does not engage securely or is deformed.




Hide 33820B 3.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Install the transmission control cable assembly to the control cable bracket assembly with 2 new clips (B).

NOTICE:

Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket assembly before installing the clips.



b.

Connect the transmission control cable assembly to the manual transaxle assembly with the 2 clips (A).


Hide 74404A 4.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 6.INSTALL AUXILIARY BATTERY

Hide 17701 7.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 9.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

a.

Engage the 2 guides and connect the air cleaner cap sub-assembly together with air cleaner hose assembly to the air cleaner case sub-assembly.


b.

Secure the air cleaner cap sub-assembly with the 2 clamp hooks.


c.

Install the air cleaner cap with air cleaner hose to the throttle body with motor assembly and tighten the hose clamp.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


d.

Connect the clamp.


e.

Connect the connector.


Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 11. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART