33333
1.INSPECT 3RD GEAR THRUST CLEARANCE
33336
2.INSPECT 5TH GEAR THRUST CLEARANCE
33333
3.INSPECT 3RD GEAR RADIAL CLEARANCE
33334
4.INSPECT 4TH GEAR RADIAL CLEARANCE
33336
5.INSPECT 5TH GEAR RADIAL CLEARANCE
33336
6.REMOVE 5TH GEAR
Using SST and a press, remove the rear input shaft radial ball bearing, No. 3 transmission hub sleeve, 5th gear synchronizer ring and 5th gear from the input shaft.
Support the input shaft by hand to prevent it from dropping.
Set the claw of SST between the 4th gear and 5th gear, as shown in the illustration.
Do not excessively tighten SST.
33393
7.REMOVE NO. 3 TRANSMISSION CLUTCH HUB
Remove the 2 No. 1 shifting key springs from the No. 3 transmission clutch hub.
Remove the No. 3 transmission hub sleeve from the No. 3 transmission clutch hub.
Remove the 3 No. 3 shifting keys from No. 3 transmission clutch hub.
33336A
8.REMOVE 5TH GEAR NEEDLE ROLLER BEARING
Remove the 5th gear needle roller bearing from the input shaft.
33336B
9.REMOVE 5TH GEAR BEARING SPACER
Remove the 5th gear bearing spacer from the input shaft.
33334
10.INSPECT 4TH GEAR THRUST CLEARANCE
33336C
11.REMOVE 5TH GEAR SHAFT SNAP RING
Using a snap ring expander, remove the 5th gear shaft snap ring from the input shaft.
Do not damage the journal surface of the input shaft.
33346B
12.REMOVE 5TH GEAR THRUST WASHER
Remove the 5th gear thrust washer from the input shaft.
33346C
13.REMOVE 5TH GEAR THRUST WASHER BALL
Using a magnet hand, remove the 5th gear thrust washer ball from the input shaft.
33334
14.REMOVE 4TH GEAR
Remove the 4th gear from the input shaft.
33334A
15.REMOVE 4TH GEAR NEEDLE ROLLER BEARING
Remove the 4th gear needle roller bearing from the input shaft.
33334B
16.REMOVE 4TH GEAR BEARING SPACER
Remove the 4th gear bearing spacer from the input shaft.
33368H
17.REMOVE 4TH GEAR SYNCHRONIZER RING
Remove the 4th gear synchronizer ring from No. 2 transmission clutch hub.
33362A
18.REMOVE NO. 2 CLUTCH HUB SETTING SHAFT SNAP RING
Using a snap ring expander, remove the No. 2 clutch hub setting shaft snap ring from the input shaft.
Do not damage the journal surface of the input shaft.
33333
19.REMOVE 3RD GEAR
Using SST and a press, remove the No. 2 transmission hub sleeve, 3rd gear synchronizer ring and 3rd gear from the input shaft.
Do not excessively tighten SST.
Support the input shaft by hand to prevent it from dropping.
33362
20.REMOVE NO. 2 TRANSMISSION CLUTCH HUB
Remove the 2 No. 1 shifting key springs from the No. 2 transmission clutch hub.
Remove the No. 2 transmission hub sleeve from the No. 2 transmission clutch hub.
Remove the 3 No. 2 shifting keys from the No. 2 transmission clutch hub.
33333A
21.REMOVE 3RD GEAR NEEDLE ROLLER BEARING
Remove the 3rd gear needle roller bearing from the input shaft.
33311A
22.REMOVE FRONT INPUT SHAFT BEARING
Using a press, remove the input shaft front bearing from the input shaft.
Support the input shaft by hand to prevent it from dropping.